Parts

  • 1x 20x20 409mm
  • 4x 20x20 384mm
  • 4x 20x20 309mm
  • 3x 20x20 99mm
  • 4x 20x20 59mm
  • 1x 20x20 149mm
  • 5x 20x20 245mm

Assembly

Base

  • 4x 20x20 245mm
  • 4x 20x20 59mm
  • 4x 20x20 384mm
  • 27x L-pieces
  • 54x grub screws
  • 1x 149mm
  • 1x 99mm

Attach the 149mm length to the 99mm length. Attach the 99mm length loosely to one of the 384mm lengths and the 149mm length loosely to one of the 245mm lengths. Ensure that the entire assembly is to be the "base" (contact with the ground): the 149+99 is to hold the PSU.

Attach the 245mm lengths to the interior (end to side) of the longer 384mm extrusion, so that width is (245+20+20). Likewise attach the 59mm uprights to the 384mm extrusion so that height is (59+20+20).

Recommended is for all grub screws to be loose initially and only tightened once parts are in place. Also recommended to only tighten grub screws when lengths are on a flat surface to ensure proper edge matching.

Upright

  • 1x 20x20 409mm
  • 1x 20x20 245mm
  • 2x 20x20 99mm
  • 4x 20x20 309mm

Attach all four 309mm loosely to the base, two each side. Attach the 409mm length to the top of two 245mm lengths. Attach the two 99mm lengths to the 245mm length, ensuring that the width is (245+20+20). Attach the resultant C-shape on top of the two 309mm uprights and also to the long 409mm.

Recommended is for all grub screws to be loose initially and only tightened once parts are in place. Also recommended to only tighten grub screws when lengths are on a flat surface to ensure proper edge matching.

Printbed Rod Holders

  • 4x printbed rod holders
  • 2x 8mm rods
  • 8x 10mm M3 hex bolts
  • 8x 20x20 M3 T-nuts
  • 8x Grub screws (not included)

These will need filing internally to remove the print burs: use a round file only. BE CAREFUL when inserting the rods: DO NOT apply pressure. They will snap as they are printed upright. Remember to insert the grub screws before putting in the M3 bolts.

Recommendation: only insert 4 of the grub screws (two per rod) so that lengths can be adjusted.